9/29/2020 0 Comments Mazak M51 Code
G92.1 V3 cancel offset coordinate systems and set parameters to zero.G92.2 V3 cancel offset coordinate systems but do not reset parameters.
M6 RG Tool change. Mazak M51 Code Code Wáits UntilThis code wáits until the tooIhead is ready béfore proceeding. This is oftén used to wáit for a tooIhead to reach thé its set témperature before beginning á print. M31 MF Output time since last M109 or SD card start to serial. M71 RG Pause activity and display message, resuming build on button push. If timeout is specified and no button is pushed, machine should shut down or reset. M72 RG Play a song or tone defined by the machine, by a P-code specifying a song type. Default songs are Error Sound (P0), a Ta-da sound (P1), and a warning sound (P2). Valid P vaIues are 0 to 100, values over 100 are rounded down to 100. M83 MF Set E codes relative while in Absolute Coordinates (G90) mode. M84 MF Disable steppers until next move, or use S to specify an inactivity timeout, after which the steppers will be disabled. M109 RR Snnn set build platform temperature in degrees Celsuis. M120 RR M121, M122 Snnn set the PID gain for the temperature regulator (not currently supported by ReplicatorG). M123 RR M124 Snnn set iMax and iMin windup guard for the PID controller (not currently supported by ReplicatorG). M126 RG valve open (acceleration on for subsequent instructions in the Jetty Firmware). M127 RG valve close (acceleration off for subsequent instructions in the Jetty Firmware). M201 MF Set max acceleration in unitss2 for print moves (M201 X1000 Y1000). M202 MF Set max acceleration in unitss2 for travel moves (M202 X1000 Y1000) Unused in Marlin. M202 RR clear buffer (not currently supported by ReplicatorG). M203 MF Set maximum feedrate that your machine can sustain (M203 X200 Y200 Z300 E10000) in mmsec. M204 MF Set default acceleration: S normal moves T filament only moves (M204 S3000 T7000) im mmsec2 also sets minimum segment time in ms (B20000) to prevent buffer underruns and M20 minimum feedrate. M205 MF advanced settings: minimum travel speed Swhile printing Ttravel only, Bminimum segment time X maximum xy jerk, Zmaximum Z jerk, Emaximum E jerk.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |